Manifold block

china hudraulic manifold block manufacturer- Manifold block

Gear pump removal steps

 

Gear pump removal

 

First step: Remove the screw with a socket wrench, and remove the pump cover – China manifold block manufacturer

 

Remove screws with socket wrench and remove pump cover

 

Second step: Remove the rear pump cover – China manifold block manufacturer

 

Remove the rear pump cover

 

Three steps: Remove the end seal ring from the rear pump cover – China manifold block manufacturer

 

Remove end seal ring from rear pump cover

 

Fourth step: Take out the pump body and the main and slave gear shaft – China manifold block manufacturer

 

Take out the pump body and the main and slave gear shafts

 

Step five: Remove the floating side panel. – China manifold block manufacturer

 

Remove floating side plates

 

Sixth step: Remove the sealing ring and sealing baffle ring from the side panel – China manifold block manufacturer

 

 

 

Seventh step: Use a special tool to remove the buckle – China manifold block manufacturer

 

 

 

Step 8: Screw in and pull out the oil port plug – China manifold block manufacturer

 

 

 

Gear pump assembly steps

 

 

 

First step: Put the sealing ring on the front cover

 

Install a sealing ring on the front cover

 

Second step: set up the pump body

 

Set up the pump body

 

Third step: install the new sealing ring and retainer ring on the side panel

 

Install new seals and retainers on the side panels

 

Fourth step: put the installed side plate into the pump body hole

 

 

Fifth step: install the main and from the gear shaft

 

 

Six steps: put a sealing ring on the back cover

 

 

 

Seventh step: install the rear cover onto the gear shaft with the positioning pin, tighten the installation screws diagonally, and finally load the shaft seal and the baffle ring – China manifold block manufacturer

Back to the homepage

manifold-block-news

china manifold block manufacturers- Manifold block